Measurement range:
NFe probe: 0 – 3000 μm
Fe probe: 0 – 3000 μm
Display resolution: 1 μm
Accuracy: ±(2 μm + 3% of measurement)
Minimum measuring surface: 10 x 10 mm
Smallest bending radius: Rmin=5mm (outside of tubes), Rmin=25mm (inside of tubes)
Minimum substrate thickness: 0.2 mm (Fe), 0.05 mm (NFe)
Operating temperature: 0 – 60°C
Power supply: 2 x 1.5 V AA type batteries
Dimensions: 100 x 62 x 27mm
Weight: approx. 130 g with batteries
Byko Test 4500 FE/NFE
Sku: 703963
Byk-Gardner
The strong points
€672.00
€806.40
Byko-Test 4500 Film Thickness Gauges enable the following to measure a variety of products.
No cable change required when changing from ferrous material to non-ferrous substrate type material. Large LCD display and 10 seconds. Storing the last measured value makes the byko-test 4500 easy to use:
■ Compact handheld device
■ One-handed design for ease of use
■ Switchable from mils to microns
■ Rugged, wear-resistant ruby probe tip
■ V-groove probe for positioning on cylindrical parts
■ Acoustic signal for measurement confirmation
■ Automatic media recognition
■ Extended measuring range
■ Faster measurement speed
■ Graphic display with backlight
The device is powered by 2 AA type 1.5V alkaline batteries located in a compartment on the back of the device. If the “BAT” indicator appears on the right side of the display, then the batteries should be changed. However, it is still possible to take a few measurements before complete extinction.
of the device.
| Caractéristiques techniques |