Metrix OX9304 - Portable oscilloscope 4x300 MHz

Oscilloscope: triggering, automatic measurements, MATH functions
An oscilloscope with complex triggering functions to only record what is necessary and capture all faults.
The OX 9000 offers advanced triggers, which are added to the main triggering possibilities on the front: pulse width, counting, delay.
- The delay mode allows the observation of any event with maximum resolution, even if it occurs long after the actual triggering, even on 2 different channels.
- The counting mode allows the counting of events prior to triggering, in order to verify the content of digital frames, for example.
The triggering can be associated with a second "auxiliary" signal different from the "main" signal.

Automatic measurements: up to 20 parameters of a signal for each channel.

Fast Fourier Transform (FFT) in real-time:
- measurement of different harmonics or signal distortion
- analysis of an impulse response
- searching for noise sources in logic circuits

Harmonics analysis:
Harmonics analysis on the 4 channels is carried out up to the 63rd rank to meet the requirements of standard EN 50160 (THD on a minimum of 50 ranks), with a fundamental frequency between 40 and 450 Hz.
It is possible to pre-select the fundamental frequency for standards (50 Hz, 60 Hz, and 400 Hz).
This function improves analysis performance, especially when measuring when the level of a harmonic rank is higher than the fundamental.
It is possible to simultaneously visualize harmonic analyses of two or four channels: RMS level, harmonic distortion, harmonic frequency, harmonic phase relative to the fundamental.

Multimeter:
A simple selection of the dedicated icon provides access to the multimeter without changing input channels. True RMS digital multimeter with 8,000 points on two or four channels, the OX 9000 performs the following measurements:
XX amplitude (DC or AC voltage and current, power, temperature, etc.)
XX resistance, continuity, capacitance
XX component testing
Temperature measurement is carried out via Pt 100 and Pt 1000 sensors, or type K thermocouples through dedicated PROBIX sensors.

Recorder/logger
This is the recording mode of the multimeter mode trends. For monitoring over time of variations in physical or mechanical phenomena, a true fast digital recorder in the instrument.
It allows acquisition speeds of up to 40 μs between 2 measurements and recordings can range from 2 seconds to one month.
Harmonics
4 simultaneous channels
Lissajou: XY
Measurement between H and V cursors: T1, T2, Dt, 1/Dt, V1, V2, dV, Ph
State

An oscilloscope SCOPIX IV comes with: 1 carrying case 1 power adapter/charger PA40W-2 and 1 EURO 2P power cord 1 Li-Ion battery pack 1 stylus 1 Ethernet cable 1 USB cable 2 safety leads (red, black) 2 Ø 4 mm touch tips (red, black) 2 or 4 voltage probes depending on the model 1 μSD card (8 GB) 1 USB/μSD adapter 1 hand strap 1 PROBIX BANANA 1 USB installation procedure for ScopeNet data export software on CD-ROM 1 .pdf operating manual on CD (>5 languages) 1 paper quick start guide 1 safety sheet in 20 languages