Metrix OX9102 - Portable oscilloscope 2x100 MHz

The oscilloscope: triggering, automatic measurements, MATH functions
An oscilloscope with complex triggering functions to only record what is necessary and capture all faults.
The OX 9000 offers advanced triggering capabilities, in addition to the main triggering possibilities on the front: pulse width, counting, delay.
- The delay mode allows the observation of any event with maximum resolution, even if it occurs long after the actual trigger, even on 2 different channels.
- The counting mode allows the counting of events prior to the trigger, in order to verify the content of digital frames, for example.
The trigger can be associated with a second "auxiliary" signal different from the "main" signal.

Automatic measurements: up to 20 parameters of a signal for each channel.

Fast Fourier Transform (FFT) in real time:
- measurement of different harmonics or signal distortion
- analysis of an impulse response
- search for noise sources in logic circuits

Harmonics analysis:
Harmonics analysis on the 4 channels is performed up to the 63rd rank to meet the requirements of the EN 50160 standard (THD on a minimum of 50 ranks), with a fundamental frequency between 40 and 450 Hz.
It is possible to pre-select the fundamental frequency for standards (50 Hz, 60 Hz, and 400 Hz).
This function improves analysis performance, especially measuring when the level of a harmonic rank is higher than the fundamental.
It is possible to simultaneously visualize harmonic analysis of two or four channels: RMS level, harmonic distortion, harmonic frequency, phase of the harmonic compared to the fundamental.

Multimeter:
A simple selection of the dedicated icon provides access to the multimeter without changing measurement input channels. True 8,000-point TRMS digital multimeter with two or four channels, the OX 9000 performs the following measurements:
XX amplitude (DC or AC voltage and current, power, temperature, etc.)
XX resistance, continuity, capacitance
XX component testing
Temperature measurement is carried out via Pt 100 and Pt 1000 sensors, or type K thermocouples through dedicated PROBIX sensors.

Recorder/logger:
This is the recording mode of the multimeter trend mode. For monitoring over time of variations in physical or mechanical phenomena, a true fast digital recorder in the instrument.
It allows acquisition speeds of up to 40 μs between 2 measurements and recordings can range from 2 seconds to one month.
Harmonics
4 simultaneous channels
Lissajou: XY
Measurement between H and V cursors: T1, T2, Dt, 1/Dt, V1, V2, dV, Ph
State

An SCOPIX IV oscilloscope comes with: 1 carrying case 1 power adapter/charger PA40W-2 and 1 EURO 2P power cord 1 Li-Ion battery pack 1 stylus 1 Ethernet cable 1 USB cable 2 safety leads (red, black) 2 Ø 4 mm test probes (red, black) 2 or 4 voltage probes depending on the model 1 μSD card (8 GB) 1 USB/μSD adapter 1 hand strap 1 PROBIX BANANA 1 USB installation procedure for ScopeNet data export software on CD-ROM 1 operating manual .pdf on CD (>5 languages) 1 paper quick start guide 1 safety sheet in 20 languages